Recoda 4CH MINI Mobile DVR Manuel d'utilisateur

Mini Stand-Alone 1 Ch / 2 ~ 4 Ch Sequence View & Record Mobile DVR User Manual (104CF-A)

9 BEFORE OPERATION (1) The system will auto detecting the hardware and enter Recording mode while hardware is in normal condition. (2) T

10 PASSWORD： ＊＊＊＊ OPERATION The system is preset [KEY LOCK] mode [OFF], when the system setting [KEY LOCK] mode [ON], the screen will show below

11 (Down Key) Go Down (Left Key) Go Left (Right Key) Go Right (Enter Key) ENTER next page 2、 Play operation key Key Operation Remarks

12 The DVR system is preset to work in Mode 2. If you want to change it to Mode 1, please switch the select switch to Mode 1. (The select switch is a

13 MAIN TITLE SETUP DATE/TIME VIDEO SETUP MOTION DETECT EVENT LIST AUTO SEQUENCE RECORD SETUP SYSTEM SETUP PERIPHERAL SETUP KEY LOCK：OFF NETWORK CF /

14 SETUP DATE/TIME YEAR : 2006 MONTH : 01 DAY : 01 HOUR : 18 MIN : 08 SEC : 08 MODE: YY:MM:DD DATE/TIME SETUP DATE/TIME DAYLIGHT SAVING TIME F

15 DAYLIGHT SAVING TIME TURN: OFF START TIME MONTH : 04 DAY : 02 HOUR : 02 END TIME MONTH : 10 DAY : 29 HOUR : 02 G. Use

16 MOTION DETECT SELECT CH CH01 CH02 CH03 CH04 a. Brightness: Brightness is adjustable, “00” = the darkest, “63” = the lig

17 MOTION DETECTION_CH1 TURN：：：：ON (or OFF) RELAY OUTPUT: ON (or OFF) F. Press key to exit for select other setting mode or p

18 AUTO SEQUENCE CH01: ON CH02: ON CH03: ON CH04: ON TIME INTERVAL: 5.0 6. Auto Sequence Setting A. Press key to enter menu selection mode.

1 TABLE OF CONTENTS Table of Contents ……………………………………………………………………… 1 Introduction …………………………………………………………………………….. 2 Important Safety Information …………

19 E. Press Key to enter selected section for setting, then use / key to select the section for setting and use / key to select the val

20 c. Alarm / Motion Record: for set-up 4 level record quality, 10 kinds frame rate and duration for record while detect alarm or motion. * Re

21 * Set “ALARM/MOTION RECORD” mode and then select “PRE-RECORD: ON”. The system will record 100 images in the hard disk before event det

22 b. Password: for change pass word. (initial password: 0000) c. PTZ: for setting protocol, baud rate. * Protocol: PELCO-D / PELCO-P * Baud Ra

23 * Device: GPS / DIAL * Baudrate: 2400 / 4800 / 9600 / 14400 / 19200 / 38400 / 57600 / 115200 * Dial mode: TONE / PULSE g. DVR ID: for setting D

24 value for setup. E. Press key to exit for other setting or press key and keep more than 2 second to exit OSD setting operation.

25 MAIN TITLE SETUP DATE/TIME VIDEO SETUP MOTION DETECTION EVENT LIST AUTO SEQUENCE RECORD SETUP SYSTEM SETUP PERIPHERAL SETUP KEY LOCK：ON/OFF NETWOR

26 PLAY BACK RECORD DATA There are two ways to playback the record data. 1. Playback by Time: Press the “Play” button, the screen will disp

27 PTZ CAMERA SETTING AND CONTROL 1. Introduction: Connect the Signal I/O box to the DVR. The signal I/O box has RS485 ports for PTZ camera control.

28 4. PTZ control: How to move PTZ camera? The process is as follows: 1. Press PTZ button. 2. Select Channel to control. 3. Press Up key to move cam

2 INTRODUCTION Thank you for purchasing our unique DVR system. To ensure that you optimize the full capabilities of this product, please read this us

29 PC PLAYER SOFTWARE OPERATION 1. Install PC player software. 2. Control panel and function. Open the file 4 splits Save singl

30 Minimize / Exit  Watermark Protection: The system will show the warning light and stop playing when the recorded data is abnormall

31 3. How to play the file (1) Open the recorded file. (2) Select the file location. (3) Select the file.

32 (4) Press “Search” button to select recorded data stored on the disk and then press “Open” button. (5) Press “Play” button to start playback.

33 (7) Press “AVI” button to start transfer function. Select start time & end time, select transferred channel and transferred quality and savin

34 (10) Play. (11) Adjust Audio Channel 1 or Channel 2.

3 UNPACKING YOUR SYSTEM Your DVR system will include the followings: 1 x Mini DVR 1 x DC connector 1 x Key on/Key start cord 2 x Cover for Key o

4 Optional Accessories  CF Card  Car rear view camera  Car rear view camera  CCD color dome camera  Shatter proof CCD color dome c

5 CONTROL PANEL AND FUNCTION Front Panel 1. Power indicator 2. CF card slot 3. CF card indicator 4. IR remote control receiver

6 IR Remote Control 1. Power On/Off button 2. Menu button 3. Record button 4. PTZ button 5. Up key (Camera 1) 6. Down key (Came

7 Installation DVR Installation Please refer to the installation process as the following drawing: 1. CF Card installation Insert the CF card into

8 5. System Camera installation Connect one end of camera cable to Camera and the other end to Video Input terminal at the back of DVR